Canon REALiS SX80 Mark II D - Manual (Page 40)

Connecting the Projector
40
Connecting the Projector to the Computer
Connect the projector to the computer.
Before connecting the cables, turn off both the projector and computer.
■Connecting to RGB Monitor Output Terminal (analog connection)
Supplied computer connection cable (Input signal type: [ANALOG PC-1] - P54 )
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor
turns down the sound.
Computer
Monitor output
terminal
(mini D-sub 15-pin)
Audio output terminal
(AUDIO OUT)
Supplied computer connection cable
(SX80 II)
Supplied VGA cable (SX800)
Commercial audio cable
To ANALOG PC-1/
DVI-I IN
To AUDIO IN
Projector
To input a corresponding
audio signal:
To ANALOG
PC-1