Starting projection, Lamp – Canon REALiS SX80 Mark II D User Manual
Page 49
49
Proje
cti
ng
an
Im
age
Starting Projection
1
Check the connection between the projector and a computer or AV equipment. (
)
2
Connect the power cord and make sure that the [POWER] indicator lights up red.
Flashing red [POWER] indicator indicates that the lamp is being cooled. Wait until the
indicator turns a steady red.
• Fully insert the power cord plug into the socket.
• Connect the ground terminal on the power plug to ground. Otherwise, an electric
shock may result or the computer may suffer electromagnetic radiation problems or
be subject to poor reception by TV and radio.
• Wait at least 5 minutes before turning on the projector when you turn off the projector.
It may shorten the lamp life if you turn on the projector immediately after turning it off.
• To save power, unplug the power cord when not in use.
3
Remove the lens cap and press the POWER button.
The POWER indicator flushes green, and then lights in green.
The countdown window is displayed for approximately 20 seconds, and then the pro-
jection is started. Press the OK button to make the countdown window disappear.
4
Turn on the computer or AV equipment power.
Remote control
Top control