Canon REALiS SX80 Mark II D - Manual (Page 55)

55
Selecting an Input Signal (INPUT)
Proje
cti
ng
an
Im
age
■Selecting an Input Signal
1
Press the INPUT button to pop up a window shown at the lower right.
The currently active input signal is marked with a circle and highlighted in orange.
An input signal that is ready for projection is displayed in white. When no signal is
received, it is displayed in gray.
In SX80 MarkII, [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be displayed in
gray even if they are ready for projection.
2
The selection is toggled through available input signal types by pressing the INPUT
button.
• You can select the target input signal with [ ] / [ ].
• Only the input signals displayed in white can be selected.
3
Press the OK button to determine the input signal type.
If no button is pressed in 4 seconds, the selected input signal type is chosen.
When you select [USB] with no PictBridge enabled equip-
ment or an USB flash memory connected and pressing the
OK button, a window waiting for you to connect a Pict-
Bridge enabled equipment or an USB flash memory
appears. For more details, refer to "Projecting an Image
from a Digital Camera (SX80 II)" (
P114 – P117 ) or "Project-
ing Data on USB Flash Memory (SX80 II)" ( P118 – P124 ).
Remote control Top control SX80 MarkII SX800
<
<