HP Netserver L Server series - Manual (Page 125)

Chapter 13 Alternative Rack Mounting (4–Post)
119
Marking the Columns
To make it easier to install the slides in the rack, you may want to mark the
columns to indicate the server placement. Use the HP Rack Configuration Tools to
determine where in the rack to mount the HP Netserver. The tools are available at
the following URL:
http://www.hp.com/netserver/support
Use a marking pen or masking tape to mark the server position on the inside of the
front and rear columns, as shown in Figure 13-2.
The slides will use the second column hole, counting from the base of the
HP Netserver.
Inside Face of Column
Masking
Tape or
Marker
Bottom of
HP Netserver
Left
Side
Right
Side
Rear of
Rack
Mark this face of
the columns with
masking tape
or marker pen.
Front of
Rack
Figure 13-2. Marking Server Placement