HP Netserver L Server series - Manual (Page 17)

Chapter 2 Opening and Closing the HP Netserver
11
4. Release the top cover by turning the knob at the front of the chassis in a
clockwise direction. See Figure 2-2.
5. Slide the top cover about ½ inch (13mm) toward the front of the Netserver
and then lift it off the chassis.
Figure 2-2. Removing the Top Cover
Replacing the Top Cover
To replace the cover, follow these steps.
1. Ensure the knob on the cover is turned to the Open position (clockwise).
See Figure 2-3.
2. Place the rear edge of the top cover near the rear edge of the chassis, angling
the cover slightly to engage the hooks at the rear of the chassis. Then lay the
cover down on the chassis.