HP Netserver L Server series - Manual (Page 16)

Chapter 2 Opening and Closing the HP Netserver
10
Figure 2-1. Removing the Front Bezel
Replacing the Front Bezel
1. Hook the bottom edge of the bezel onto the pins at the front of the chassis.
See Figure 2-1.
2. Close the bezel and press the top corners to snap it into place.
Removing the Top Cover
You do not need to remove the front bezel to remove the top cover of the
Netserver.
1. If the HP Netserver is operating, log off all users and shut down the operating
system.
2. Pull out the anti-tip foot at the bottom of the rack. Then slowly slide the HP
Netserver chassis out from the rack.
3. Disconnect the power cord and unplug cables.