47 replacing the drive cover, 48 replacing the bezel – HP D2D100 Backup System User Manual
Page 120
Advertising
Figure 47 Replacing the drive cover
12.
Insert the two hooks on the right side of the bezel into the rectangular holes on the chassis (1).
Rotate (2) the bezel into place so that the three tabs on the left side of the bezel snap into the
slots on the chassis.
Figure 48 Replacing the bezel
13.
Use two hands to place the access panel flat against the chassis (1), the back of the access panel
extending about 2.5 cm (1.0 in) behind the back of the server. Make sure the hooks on the access
panel align with the holes on the edges of the chassis. Slide (2) the access panel toward the front of
the chassis to position it into place. Tighten the captive thumbscrew (3) to secure the access panel.
120
Hard disk replacement
Advertising