Run the installation wizard, 25 powering on the hp d2d backup system – HP D2D100 Backup System User Manual
Page 40
1. LEDs
2. Power On button
Figure 25 Powering on the HP D2D Backup System
Run the Installation wizard
The HP D2D Backup System can be used to back up a maximum of six hosts. You should run the
Installation wizard on each host that will provide a source of data for backup. The host may be a
server, workstation or PC.
1.
Insert the CD-ROM supplied with your HP D2D Backup System into the host machine. It should launch
automatically. If it does not, locate the D2DInstallationWizard.exe file and run it manually.
2.
Select Start the wizard and follow the onscreen instructions to step through the installation, normally
by pressing Next.
The Installation wizard will automatically configure all the software components required for setup
and use of the HP D2D Backup System. There are three main phases:
• Install the tape drivers: These allow your system to recognize the tape drives created on the
HP D2D Backup System.
40
The Installation wizard