HP D2D100 Backup System - Manual (Page 23)

2 Connecting and installing the HP
D2D Backup System
In this chapter:
• “ Connect the hardware ” on page 23
• “ Supported network configurations ” on page 24
• “ Software installation, discovery and configuration ” on page 26
• “ Web browser settings ” on page 26
Connect the hardware
1. Network connector
2. Power connector
Figure 5 Network and power connectors
1.
Always use the supplied power cord to connect the HP D2D Backup System to the main power
supply. This HP-approved cord is appropriate for your specific geographic region.
For detailed safety information, see the Safety Guide on the HP StorageWorks CD-ROM.
2. Use the supplied network cable to connect to a Gigabit network switch. 100 Base-T Ethernet will limit
performance; 10 Base-T Ethernet will severely limit performance. For example network topologies,
see “ Supported network configurations ” on page 24.
D2D Backup System 23