Installing the hba, 12 removing the front bezel, 13 removing the slot cover retainer – HP D2D100 Backup System User Manual
Page 31
Figure 12 Removing the front bezel
Installing the HBA
CAUTION:
Static electricity can damage electronic components. Always wear an antistatic wriststrap if one is
available. If not, after you have disconnected power from the server and removed the cover, touch a bare
metal part of the chassis. Similarly, touch a bare metal part of the drive before installing it.
The supported PCI-Express HBA should be installed in the top PCI slot. Please refer to
www.hp.com/go/connect
for a list of all supported host bus adapters and tape drives. No additional
drivers are required for recommended HBAs and tape drives; they are included in the HP D2D Backup
System firmware.
1.
Undo the retaining screw (1) and remove the slot cover retainer (2).
Figure 13 Removing the slot cover retainer
2.
Remove the cover from the top expansion slot.
D2D Backup System
31