4 the installation wizard, Before you install the first host, Installation wizard – HP D2D100 Backup System User Manual
Page 39
4 The Installation wizard
This chapter is relevant for users installing on a Windows host. If you are installing on a Linux system,
please refer to the “Linux Configuration Guide” on the HP StorageWorks Tape CD-ROM.
In this chapter:
•
Before you install the first host
•
If you are installing on a Windows system, the Installation wizard is the recommended way to set up a host
machine to work with the HP D2D Backup System, particularly if you are configuring the host for the first
time. The wizard automatically configures all the software components needed to connect and use the HP
D2D Backup System. It should be run on all hosts that are to be backed up to the HP D2D Backup System.
If you are not using the Installation wizard to install on a Windows system, please see
Before you install the first host
You must have the necessary administrative rights on the host to run the Installation wizard successfully.
1.
Make sure the host machine on which you are running the Installation wizard has Internet
access. If it does not, you will have to download the Microsoft ® iSCSI Initiator manually. See
2.
Press the Power on button on the front of your HP D2D Backup System. During power on the LEDs will
perform a self-test sequence; all LEDs with the exception of the status LED will then be extinguished
until the boot sequence is completed.
D2D Backup System
39