HP D2D100 Backup System - Manual (Page 63)

8 The Web Management Interface
In this chapter:
• “ Web management interface ” on page 63
• “ To run the Web Management Interface ” on page 63
• “ Summary (Home) ” on page 64
• “ Devices (Configuration) ” on page 65
• “ Cartridges (Configuration) ” on page 67
• “ Network (Configuration) ” on page 71
• “ Email Alerts (Configuration) ” on page 74
• “ Disk & RAID (Status) ” on page 76
• “ iSCSI (Status) ” on page 77
• “ Log (Status) ” on page 78
• “ Shutdown (Admin) ” on page 79
• “ Administration (Admin) ” on page 80
• “ Firmware (Admin) ” on page 81
• “ Support (Admin) ” on page 82
What is the Web Management interface?
The Web Management Interface is the main interface for:
• Monitoring the status and health of the HP D2D Backup System and all configured backup devices
• Changing the number of cartridge slots or creating additional autoloaders, or standalone tape
drives, for a host
• Managing movement of data to and from a physical tape drive attached to the HP D2D (if
one has been installed)
To run the Web Management Interface
There are two ways of logging on:
• From the host server or PC: Use the desktop shortcut created by the Installation wizard.
• From any machine connected to the network: Enter the IP address or fully qualified domain name
(for example, myhpd2d.mydomain.com) of the HP D2D Backup System into the web browser.
The Web Management Interface displays the Login prompt:
The Login is Administrator with an initial password of Admin.
Both names are case sensitive. The password can subsequently be changed from the Administration menu
option, see “ Administration (Admin) ” on page 80.
D2D Backup System 63