HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 24)

24 C ONFIGURING THE HP EFS WAN A CCELERATOR
2. Use the controls to complete the configuration, as described in the following table.
Control Description
In-Path Enable In-Path Support. Specify this option to enable optimization on traffic that is in
the direct path of the client, server, and HP EFS WAN Accelerator.
Reset Existing Client Connections on Startup. Specify this option to enable kickoff. If
you enable kickoff, connections that exist when the HP EFS WAN Accelerator service is
started and restarted are disconnected. When the connections are retried they are
optimized.
Generally, connections are short lived and kickoff is not necessary. It is suitable for very
challenging remote environments. For example, in an environment with 128 kbps and 1.5
seconds of latency, you might want to abort an HTTP download so that your traffic is
optimized, whereas in a remote branch-office with a T1 and 35 ms round-trip time, you
would want connections to migrate to optimization gracefully, rather than risk
interruption with kickoff.
NOTE: Do not enable kickoff for in-path HP EFS WAN Accelerators that use auto-
discovery or if you do not have an HP EFS WAN Accelerator on the remote side of the
network.
Enable L4/PBR/WCCP Support on Interface <interface_name>. Specify this option
to enable optional, virtual in-path support on the named interface. External traffic
redirection is supported only on the first in-path interface. The following redirection
methods are available:
• Layer-4 Switch. You enable Layer-4 switch support when you have multiple HP EFS
WAN Accelerators in your network, so that you can manage large bandwidth
requirements.
• Policy-Based Routing (PBR). PBR allows you to define policies to route packets
instead of relying on routing protocols. You enable PBR to redirect traffic that you
want optimized by an HP EFS WAN Accelerator that is not in the direct physical path
between the client and server.
• Web Cache Communication Protocol (WCCP). If your network design requires you
to use WCCP, a packet redirection mechanism directs packets to HP EFS WAN
Accelerators that are not in the direct physical path to ensure that they are optimized.
For detailed information about configuring Layer-4 switch, PBR, and WCCP
deployments, see the HP StorageWorks Enterprise File Services WAN Accelerator
Deployment Guide.
Enable Optimizations on Interface <interface_name>. Specify this option to enable
in-path support for additional bypass cards.
If you have an HP EFS WAN Accelerator that contains multiple two-port or four-port
bypass cards, the Management Console displays options to enable in-path support for
these ports. The number of these interface options depends on the number of pairs of
LAN and WAN ports that you have enabled in your HP EFS WAN Accelerator.
The interface names for the bypass cards are a combination of the slot number and the
port pairs (inpath<slot>_<pair>, inpath<slot>_<pair>). For example, if a four-port
bypass card is located in slot 0 of your appliance, the interface names are: inpath0_0 and
inpath0_1. Alternatively, if the bypass card is located in slot 1 of your appliance, the
interface names are: inpath1_0 and inpath1_1. The maximum number of pairs is six,
which is three four-port bypass cards.
For detailed information about installing additional bypass cards, see the HP
StorageWorks Enterprise File Services N4c WAN Accelerator 4-port NIC Installation
Guide.