HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 60)

60 C ONFIGURING THE HP EFS WAN A CCELERATOR
To set a static main
route 1. Click the Setup tab to display the Setup menu.
2. Click Host Settings to expand the Host Settings menu.
3. Click Routing: Main to display Host Settings - Routing: Main page.
Figure 2-18. Host Settings - Routing: Main Page
4. Use the controls to complete the configuration, as described in the following table.
5. Click Save to save your settings permanently or click Reset to return the settings
to their previous values.
Setting Static
In-Path Routes You configure static, in-path network routes if your network configuration requires
additional static in-path network routing rules in the Host Settings - Routing: In-Path
page.
The values you specify set the routing table for in-path interfaces (as opposed to the
primary interface).
Control Description
Add New Route Destination. Specify the IP address.
Netmask. Specify the subnet mask.
Gateway. Specify the IP address for the gateway. The gateway must be in the same
network as the primary or auxiliary interface.
Add Route. Specify this option to add the entry to the list.
Remove Selected Routes. To remove an entry, click the check box next to the entry and
click Remove Selected Routes.