HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 55)

HP S TORAGE W ORKS EFS WAN A CCELERATOR M ANAGEMENT C ONSOLE U SER G UIDE 55
2 C
ONF
IGUR
ING
TH
E
HP
EF
S
WA
N
A
CC
EL
ERA
T
O
R
‹ Routers are often configured with fixed speed and duplex settings. Check your
router configuration and set it to match the HP EFS WAN Accelerator WAN and
LAN settings. Make sure your switch has the correct setting.
‹ After you finish configuring the HP EFS WAN Accelerator, check for speed and
duplex error messages (crc or frame errors) in the Logging, View System Log
page of the Management Console. For detailed information about viewing HP
EFS WAN Accelerator logs, see
“Viewing HP EFS WAN Accelerator Logs” on
page 201 .
‹ If there is a serious problem with the HP EFS WAN Accelerator and it goes into
bypass mode (that is, it automatically continues to pass traffic through your
network), a speed and duplex mismatch might occur when you reboot the HP EFS
WAN Accelerator. To avoid a speed and duplex mismatch, configure your LAN
external pair to match the WAN external pair. For example, auto on the LAN and
WAN and fixed to 100 FULL on the LAN and WAN.
To set the in-path
interface 1. Click the Setup tab to display the Setup menu.
2. Click Host Settings to expand the Host Settings menu.
3. Click Interface: In-Path to display the Host Settings - Interface: In-Path (LAN/
WAN) page.
Figure 2-16. Host Settings - Interface: In-Path (LAN/WAN) Page