HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 75)

HP S TORAGE W ORKS EFS WAN A CCELERATOR M ANAGEMENT C ONSOLE U SER G UIDE 75
2 C
ONF
IGUR
ING
TH
E
HP
EF
S
WA
N
A
CC
EL
ERA
T
O
R
4. Use the controls to complete the configuration, as described in the following table.
Control Description
Failover Settings Enable Failover Support. Specify this option to enable failover support.
Current Appliance is the. Select Master or Backup from the drop-down list. A master
HP EFS WAN Accelerator is the primary appliance; the backup HP EFS WAN
Accelerator is the appliance that automatically optimizes traffic if the master appliance
fails. You must specify the primary IP address for the backup appliance.
IMPORTANT: If you have multiple bypass cards installed in your appliance you must
specify the inpath0_0 interface for the in-path IP address.
NOTE: If you have an out-of-path configuration with failover support, you must specify
the master and backup appliances in the Optimization Service - In-Path Rules page. For
detailed information, see
“Setting In-Path Rules” on page 25 .
Other Appliance’s In-path IP Address. Specify the IP address for the master or backup
HP EFS WAN Accelerator. You must specify the in-path IP address (inpath0_0) for the
HP EFS WAN Accelerator, not the primary interface IP address.
IMPORTANT: If you have multiple bypass cards installed in your HP EFS WAN
Accelerator you must specify the inpath0_0 interface for the in-path IP address.
For detailed information, see “Setting In-Path Interfaces” on page 54 .