HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 117)

HP S TORAGE W ORKS EFS WAN A CCELERATOR M ANAGEMENT C ONSOLE U SER G UIDE 117
2 C
ONF
IGUR
ING
TH
E
HP
EF
S
WA
N
A
CC
EL
ERA
T
O
R
4. Click Apply to apply your settings to the running configuration. (Apply your
settings to test a new configuration before saving them permanently.)
5. Click Save to save your settings permanently or click Reset to return the settings
to their previous values.
Setting Email
Notification You can set email notification parameters for events and failures in the
Reports - Notification page.
By default email addresses are not specified for event and failure notification.
Warning Temperature Alarm Raise Alarm When Temperature (°C) Reaches. Specify this option to trigger an alarm
when the CPU temperature exceeds the rising threshold. When the CPU returns to the
reset threshold, the rising alarm is cleared. When the CPU returns to the reset threshold,
the rising alarm is cleared. The default value for the rising threshold temperature is 70º
C; the default reset threshold temperature is 67º C.
Rising Threshold. Specify the rising temperature (º C).
Reset Threshold. Specify the reset temperature (º C).
Additional Alarms Raise Alarm When Network Interface Duplex Errors are Detected. Specify this
option to trigger an alarm if the system has encountered a large number of packet errors
in your network. Make sure the speed and duplex settings on your HP EFS WAN
Accelerator match the settings on your switch and router.
This alarm is enabled by default.
Raise Alarm When Network Interface Link Errors are Detected. Specify this option
to trigger an Simple Network Management Protocol (SNMP) trap, email, and alarm
notification when a link goes down. This alarm is disabled by default.
For WAN/LAN interfaces, an alarm is only triggered if in-path support is enabled for that
WAN/LAN pair.
Raise Alarm When Extended Memory Paging Activity is Detected. Specify this
option to trigger the memory paging alarm. If 100 pages are swapped every couple of
hours, the HP EFS WAN Accelerator is functioning properly. If thousands of pages are
swapped every few minutes, contact HP Technical Support.
This alarm is enabled by default.
Raise Alarm If a Software Version Mismatch is Detected in the Network. Specify
this option to trigger an alarm if there is a mismatch between software versions in the HP
EFS WAN Accelerator system.
This alarm is enabled by default.
Control Description