HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 142)

142 C ONFIGURING THE HP EFS WAN A CCELERATOR
TIP: Click the configuration name to display the configuration settings in a new browser
window.
IMPORTANT: You must restart the HP EFS WAN Accelerator service for a configuration to
take effect. For detailed information, see “Starting and Stopping Services” on page 144 .
Upgrading Your Software
You can upgrade or revert to a back-up version of the software in the Software Upgrade
page.
Import Configuration From IP/Host Name. Specify the IP address or host name of the HP EFS WAN Accelerator
from which you want to import the configuration.
Remote Admin Password. Specify the administrator password for the remote HP EFS
WAN Accelerator.
Remote Config Name. Specify the name of the configuration you want to import from
the remote HP EFS WAN Accelerator.
New Config Name. Specify a new, local, configuration name for this appliance.
Import Shared Data Only. This is enabled by default. Keep this option checked to copy
only the following common settings: in-path and out-of-path interface, protocols, CLI
and Web, statistics, NTP, SNMP, and alarm settings. The following settings are not
automatically copied: failover, SNMP (contact and location), log, and network settings.
Import Configuration. To perform the import configuration operation, click Import
Configuration.
The imported configuration appears in the Configuration list but does not become the
active configuration until you click Activate.