HP StoreEver MSL Tape Libraries - Manual (Page 15)

2 Configuring and operating an extended
library
This chapter provides information about extended library configuration and operation tasks that are
different from a single Tape Library.
If you are installing the Extender for the first time, read this chapter for reference after installing the
Extender following the instructions in
Chapter 3 , page 27.
TIP:
Check the Help screens in the RMI for additional information. The help pages are updated with most
firmware updates and often contain technical details that are not contained in this document. To
access RMI help, click Help on the right side of the Web page banner, as shown in
Figure
2 on page 15.
Figure 2 Help available from the RMI
.
Powering on the extended library
To power on the extended library, power on each of the Tape Libraries from their OCPs. The Libraries
can be powered on in either order. The initialization sequence is faster if the lower Library is powered
on first.
HP StorageWorks MSL Library Extender user guide 15