HP StoreEver MSL Tape Libraries - Manual (Page 57)

2. Press the power button on the master Library to power off the master Library. If the Library does
not respond to the power button, depress the power button and hold it for at least 10 seconds.
3. Disable extended mode from the lower Library Configuration > System menu.
4. Press the power button on the lower Library to power off the lower Library. If the Library does
not respond to the power button, depress the power button and hold it for at least 10 seconds.
Removing the Library Extender
To remove the Library Extender:
1. Using a #1 Phillips screwdriver, 1) loosen the four screws that secure the Extender to the Tape
Libraries, as shown in
Figure 34 , page 57.
Figure 34 Removing the Extender
. 2. Pull the Extender straight out of the Libraries.
To store or ship the Library Extender, repackage it in the original packaging materials as shown in
Repackaging the Library Extender , page 61.
Preparing the Libraries to operate as separate Libraries
Each Library must have at least one tape drive. Skip this procedure if you do not need to relocate a
tape drive from one Library to the other.
IMPORTANT:
To avoid damage to the Library, ensure that the tape drive is powered off before removing it from a
Library.
HP StorageWorks MSL Library Extender user guide 57