HP StoreEver MSL Tape Libraries - Manual (Page 32)

If either Library is mounted in a tabletop conversion cover, remove the cover and install the Library
in the rack in the rack rails supplied with the Library. If either Library needs to be moved, remove the
Library and its rack rails from the rack and install the rails and Library in the necessary rack location.
NOTE:
If the Library Extender is near the rear rack door latch, you might need to move the Libraries to a
different rack location to close and latch the rack doors.
Removing a Library from a rack or tabletop conversion cover
Unplug the power cord from the wall outlet. Remove the power cord from the Library.
Remove all other cables from the Library.
Obtain adequate assistance to lift and stabilize the Library during removal and replacement.
From the front of the Library 1) completely loosen the screws inside the left and right front bezel (these
are captive screws and cannot be removed), then 2) slide the Library out of the rack or cover using
assistance as shown in
Figure 13 , page 32.
Figure 13 Removing an MSL4048 from a rack
.
CAUTION:
Always lift the Library from the side edges. Lifting the Library from the magazine or drive openings,
or from the drive handles can damage the Library.
Installing the Library Extender 32