Replacing drive bay covers, Connecting the ethernet cable, Powering on the libraries – HP StoreEver MSL Tape Libraries User Manual
Page 58: Copying the key server token, 58 connecting the ethernet cable, 58 powering on the libraries, 58 copying the key server token
1.
To remove a tape drive from its current location, loosen the blue captive thumbscrews on the tape
drive.
2.
Pull straight back on the tape drive handle while supporting the bottom of the tape drive to remove
it from the Library.
3.
If necessary, remove one or two drive bay covers.
4.
Slide the tape drive into its new drive bay. Tighten the blue thumbscrews with your fingers to
secure the tape drive in the Library.
Replacing drive bay covers
Use a #1 Phillips screwdriver to secure drive bay covers over any open tape drive bays.
Connecting the Ethernet cable
To use the RMI with the lower Library, insert one end of an Ethernet cable into the Ethernet port on
the back of the Library. Plug the other end into an Ethernet LAN port.
Powering on the Libraries
Power on each Library from its OCP. They no longer communicate with each other and must be
configured and operated separately.
Copying the key server token
Skip this section if the extended library is not using the HP StorageWorks 1/8 G2 and MSL Encryption
Kit.
The encryption keys used to read and write encrypted data are stored on a USB key server token. In
the extended library, encryption keys are stored in the key server token installed in the master Library.
Servicing the Library Extender
58