The paper cannot be loaded successfully, The paper has jammed, Check the printhead path – HP Designjet Z6200 Photo Printer User Manual
Page 168
The paper cannot be loaded successfully
Here are a few things to check if you cannot successfully load the paper.
●
The paper might be loaded at an angle (skewed or mislocated). Make sure that the right edge of
the paper is aligned with the half-circle on the right-hand side of the platen, and that the leading
edge of the paper is aligned with the metal bar in the platen.
●
The paper might be crumpled or warped, or have irregular edges.
●
If the paper jams in the paper path to the platen, the leading edge of the paper might not be
straight or clean. Remove the initial 2 cm (1 in) of paper from the roll and try again. This might be
necessary even with a new roll of paper.
●
Make sure that the spindle is correctly inserted.
●
Make sure that the paper is correctly loaded on the spindle, and that it loads over the roll towards
you.
●
Check that the paper is wound tightly on the roll.
The paper has jammed
When a jam occurs, the Possible paper jam message usually appears in the front panel, with one
of two error codes:
●
81:01 indicates that paper cannot advance into the printer.
●
86:01 indicates that the printhead carriage cannot move from side to side.
Check the printhead path
1.
Turn off the printer at the front panel, then also switch off the power switch at the rear.
160
Chapter 14 Troubleshoot paper issues
ENWW
Troubl
eshoot paper