HP Designjet Z6200 Photo Printer - Manual (Page 51)

NOTE: If you want to move the printer, first remove the take-up reel sensor and cable housing unit
from the foot of the printer stand. Place the sensor and cable housing unit on the printer stand crossbar
and use the blue plastic screw to affix the housing unit to the leg of the stand, as shown, while the
printer is being moved. When reinstalling the housing unit, make sure that the wheel on the foot of the
printer stand is pointing forward.
Unload a roll from the take-up reel
1.
On the printer's front panel, select the icon, and then select Paper unload > Unload
take-up reel.
The printer advances the paper to allow for cutting.
2. Lift the loading table to its upright position.
3. Switch the wind-direction switch to the off position. The switch is in the off position when it is
centered (in other words, when the switch is neither in position 1 nor position 2).
ENWW Use the take-up reel 43
Handle the paper