Load a roll into the printer – HP Designjet Z6200 Photo Printer User Manual
Page 44
If you regularly use different paper types, you can change rolls more quickly if you pre-load rolls of
different paper types on different spindles. Extra spindles are available for purchase.
Load a roll into the printer
NOTE:
To start this procedure, you need to have a roll loaded on the spindle. See
.
1.
At the printer's front panel, select the
icon, and then select Paper load > Load roll.
Alternatively, you can start loading paper without using the front panel, by feeding paper in or
lifting the pinch lever when there is no paper loaded.
NOTE:
If you lift the pinch lever, you will need to align the paper manually; follow the
instructions on the front panel.
2.
If printing paper info is disabled, the front panel asks you to select the paper type.
3.
The front panel asks you to feed paper. When the printer detects the paper, paper checks will
begin.
4.
If the paper that you are using has a paper-data barcode printed on the leading edge of the roll,
and printing paper info is enabled, the printer automatically reads the information. If printing
paper info is disabled, the barcode is ignored.
If printing paper info is enabled and no barcode is detected on the roll that is being loaded, the
front panel asks you to enter the paper type and the length of the roll you are loading. Select the
paper category and paper type of the roll. If it is not clear which paper category or paper type to
select, see
Supported paper types on page 31
Select the length of the roll.
5.
If some of the paper checks failed, the front panel explains the problem and helps you to load
paper successfully.
36
Chapter 4 Handle the paper
ENWW
H
a
ndle the paper