HP StoreEver TapeAssure Software - Manual (Page 65)

6. After the software is successfully installed, enter the following commands to remove the
temporary files from the installation process:
cd /tmp
rm –rf install_hpltt
rm –rf HPLTT<xx> (where <xx> is the version number)
To determine whether L&TT is already installed on the system, use the following command:
/usr/bin/pkginfo | grep LTT
To remove a previous version of L&TT, use the following command:
/usr/sbin/pkgrm HPLTT<xx> (where <xx> is the version number)
Installing L&TT for Mac
Mac installation prerequisites
Install time (typical) Less than 4 minutes
Reboot requirements None
Software prerequisites Mac OS 10.4 or higher
Installation and uninstallation
To install L&TT on Mac:
1.
Log in to the Mac GUI using root or full system privileges.
2. Download or copy the install file to a temporary location. The install file is
hpltt_<xx>_mac.dmg
(where <xx> is the version number).
3. Double-click the downloaded file. This action will mount the image.
4. Double-click the hp_ltt<xx>.mpkg icon.
5. Follow the screen instructions.
6. On completion, click the finish button.
To remove L&TT from Mac:
•
Remove the directory /usr/local/HP/LTT.
Using the command screen interface (CSI)
Starting L&TT
To start L&TT:
•
For HP-UX (pre-11i v3), Tru64, and Linux:
Log on as root and execute the following commands:
cd /opt/ltt
./hp_ltt
•
For HP-UX 11i v3:
HP-UX 11i v3 provides a new agile addressing format, which can be seen by executing
ioscan -fN
and supports both persistent (new) and legacy Device Special Files (DSFs). Start
L&TT with the -N option to use the new agile addressing format.
Log on as root and execute the following commands:
cd /opt/ltt
For the agile addressing format and persistent DSFs: ./hp_ltt -N
For the legacy addressing format and legacy DSFs: ./hp_ltt
Using the command screen interface (CSI) 65