HP StorageWorks XP Remote Web Console Software User Manual
Page 70
Table 17 Errors during Volume Migration or Migration Cancellation by using RAID Manager
Measure
Cause
Error Code
(SSB2)
Error Code
(SSB1)
This migration plan cannot be executed.
Check the configuration definition file.
The cache mode between the migration
source volume and the migration target
volume does not match.
2027
B9AE/B9AF
This migration plan cannot be executed.
Check the configuration definition file.
The migration source volume is the
quorum disk.
2039
This migration plan cannot be executed.
Check the configuration definition file.
The migration target volume is the
quorum disk.
203a
This migration plan cannot be executed.
Check the configuration definition file.
The migration source volume uses two
mirrors in the 3DC multi-target
configuration, the 3DC cascade
configuration, or the delta resync
configuration consisting of three
Universal Replicator sites.
2045
This migration plan cannot be executed.
Check the configuration definition file.
The migration target volume uses two
mirrors in the 3DC multi-target
configuration, the 3DC cascade
configuration, or the delta resync
configuration consisting of three
Universal Replicator sites.
2046
Release the volume from Volume
Retention Manager, and then perform
the volume migration.
The Read Only attribute or the Protect
attribute is set on the migration target
volume with Volume Retention Manager.
2050
Release the volume from Data Retention
Utility, and then perform the volume
migration.
The migration target volume is being
used with Data Retention Utility.
2051
Release the volume from Volume Security,
and then perform the volume migration.
The security mode is set on the migration
target volume with Volume Security.
2052
Release the volume from XP Continuous
Access Journal, and then perform the
volume migration.
The migration target volume is being
used with XP Continuous Access Journal.
2055
Release the volume from XP Continuous
Access Journal, and then perform the
volume migration.
The migration source volume is being
used with XP Continuous Access Journal.
2056
This volume migration cannot be
executed. Check the configuration
definition file.
The migration target volume and the
migration source volume belong to the
same parity group.
2058
After the shredding operation is
completed, perform the volume
migration.
The migration source volume is being
shredded.
205A
Release the volume from XP Continuous
Access Journal, and then perform the
volume migration.
The migration target volume is being
used with XP Continuous Access Journal.
205C
Perform the following measures for each
cause:
1.
Change the XP Snapshot pair status
to PAIR, and then migrate the volume.
2.
This volume migration cannot be
executed. Check the configuration
definition file.
The migration source volume corresponds
to either of the following causes:
1.
The volume is a P-VOL of the XP
Snapshot pair. The pair is not in PAIR
status.
2.
The volume is an S-VOL of the XP
Snapshot pair or a V-VOL of XP
Snapshot.
2075
2076
70
Troubleshooting