HP StorageWorks XP Remote Web Console Software User Manual
Page 71
Table 17 Errors during Volume Migration or Migration Cancellation by using RAID Manager
(continued)
Measure
Cause
Error Code
(SSB2)
Error Code
(SSB1)
Perform the following measures for each
cause:
1.
Release the XP Snapshot pair, and
then migrate the volume.
2.
This volume migration cannot be
executed. Check the configuration
definition file.
The migration target volume corresponds
to either of the following causes:
1.
The volume is a P-VOL of the XP
Snapshot pair.
2.
The volume is an S-VOL of the XP
Snapshot pair or a V-VOL of XP
Snapshot.
Release the pool-VOL setting of XP
Snapshot from the volume, and then
perform the volume migration.
The migration source volume is a
pool-VOL of XP Snapshot.
2078
Release the pool-VOL setting of XP
Snapshot from the volume, and then
perform the volume migration.
The migration target volume is a
pool-VOL of XP Snapshot.
2079
After finishing the quick formatting,
perform the volume migration.
The migration source volume is
undergoing quick formatting.
2089
After finishing the quick formatting,
perform the volume migration.
The migration target volume is
undergoing quick formatting.
208A
Release the Mainframe Fibre Data
Migration pair, and then migrate the
volume.
The migration source or target volume is
the volume of the Mainframe Fibre Data
Migration pair.
208F
Associate the XP Thin Provisioning virtual
volume with a pool, and then perform
the volume migration.
The migration target volume is an XP Thin
Provisioning virtual volume that is not
associated with a pool.
2090
Associate the XP Thin Provisioning virtual
volume with a pool, and then perform
the volume migration.
The migration source volume is an XP
Thin Provisioning virtual volume that is
not associated with a pool.
2091
This migration plan cannot be executed.
Check the configuration definition file.
The migration target volume and the
migration source volume are the XP Thin
Provisioning virtual volumes that are
associated with the same pool.
2095
Release the pair containing the migration
source volume, and then perform the
volume migration.
The migration source volume is used by
XP Continuous Access or XP Continuous
Access Journal. The migration target
volume is an XP Thin Provisioning virtual
volume.
2096
Re-execute the volume migration plan
about 40 minutes after the system
configuration is changed.
The specified volume cannot be migrated
because the information about system
configuration updates due to volume
migration is being backed up.
2098
This migration plan cannot be executed.
Check the configuration definition file.
The volume cannot be migrated if the
emulation type of either the migration
source volume or the migration target
volume is OPEN-0V. To migrate the
volume, ensure that the emulation type
of both volumes is OPEN-0V. However,
volume migration between OPEN-V and
OPEN-0V is permissible only when the
volumes are XP Thin Provisioning virtual
volumes.
2099
This migration plan cannot be executed.
Check the configuration definition file.
209A
Troubleshooting When Using RAID Manager
71