HP 3PAR Operating System Software - Manual (Page 253)

Quick Setup: RCIP Transport Layer
Table 8 Quick Setup Steps for RCIP
Backup System Primary System Reference Step
controlport rcip addr
[-f] <port_IP>
<netmask> <N:S:P>
controlport rcip
addr [-f] <port_IP>
<netmask> <N:S:P>
“Setting Up the Remote-Copy
Interface for RCIP” (page 30) 1. On all RCIP ports, set up
the interface.
controlport rcip gw
[-f] <gateway_IP>
<N:S:P>
controlport rcip gw
[-f] <gateway_IP>
<N:S:P>
“Setting the Gateway”
(page 31) 2. On all RCIP ports, set the
gateways.
showport -rcip showport -rcip “ 3. Verify gateway IPs.
controlport rcip ping
<target_IP_address>
<N:S:P>
controlport rcip
ping
<target_IP_address>
<N:S:P>
“Verifying That the Servers
Are Connected” (page 32) 4. Verify connectivity.
a. cli checkrclink
startserver
<N:S:P>
<dest_addr>
“Checking RCIP Link
Throughput and Latency”
(page 33) 5. On all nodes and
systems, check the links.
b. cli checkrclink
startclient
<N:S:P>
<dest_addr> <time>
c. cli checkrclink
stopserver <N:S:P>
showport -rcip showport -rcip “Increasing MTU” (page 33) 4. Verify gateway IPs.
5. (If possible) On each
port, increase MTU.
controlport rcip ping
-s 8972 -pf
controlport rcip
ping -s 8972 -pf
“ 6. (If MTU increased) On
each port, verify MTU
support.
<target_IP_address>
<N:S:P>
<target_IP_address>
<N:S:P>
Quick Setup: RCIP Transport Layer 253