HP 3PAR Operating System Software - Manual (Page 68)

2. On the primary system (SystemA), add the pre-existing virtual volumes to the newly created
volume group. Issue either of the following commands:
# admitrcopyvv <VV_name> <group_name> <target_name:sec_VV_name>
<target_name:sec_VV_name>
where:
•
<VV_name> —Name of the virtual volume (testvv.A.0) to add to the primary volume
group on the primary system
•
<group_name> —Name of the primary volume group (testgroup) on the primary
system
•
<target_name> —Name of the target system (SystemB and SystemC)
•
<sec_VV_name> —Name of the corresponding secondary virtual volume on the target
system (in this example, testvv.B.0 and testvv.C.0)
or:
# admitrcopyvv -pat <pattern> <group_name> <target_name:sec_VV_name>
<target_name:sec_VV_name>
where <pattern> represents the pattern of virtual volume names (for example, testvv*)
For example:
# admitrcopyvv -pat testvv.A* testgroup SystemB:testvv.B* SystemC:testvv.C*
The admitrcopyvv command:
•
Adds the specified virtual volumes (testvv.A.0, testvv.A.1, and testvv.A.2) to
the primary volume group (testgroup) on the primary system (SystemA).
•
Adds the specified virtual volumes (testvv.B.0, testvv.B.1, and testvv.B.2 and
testvv.C.0
, testvv.C.1, and testvv.C.2) to the corresponding secondary volume
groups on the target systems (SystemB and SystemC).
Because HP 3PAR Remote Copy created these secondary volume groups (both named
testgroup.r96
) when you created the primary volume group, HP 3PAR Remote Copy
automatically adds the following:
◦
testvv.B.0 , testvv.B.1, and testvv.B.2 to testgroup.r96 on SystemB.
◦
testvv.C.0 , testvv.C.1, and testvv.C.2 to testgroup.r96 on SystemC.
Solution Problem
To redo volume groups: 1. Use the removercopygroup command.
2. Repeat the setup from Step 1 .
To redo virtual-volume placement: 1. Use the dismissrcopyvvcommand.
2. Repeat the setup from Step 2 .
For more information about these commands, see “About the Remote-Copy
Commands” (page 261) .
68 Setting Up SLD Remote Copy