HP 3PAR Operating System Software - Manual (Page 93)

10 Stopping, Starting, or Removing Remote Copy
For more information Command Manual Operation
“Stopping and Restarting Remote Copy”
(page 94) stoprcopygroup
startrcopygroup
Stop and restart remote copy groups
“Stopping and Restarting Remote Copy”
(page 94) stoprcopy
startrcopy
Stop and restart remote copy
“Removing Remote Copy Completely”
(page 94) stoprcopy Erase the remote-copy configuration
Solution Problem
Ensure that links are up on both systems and try the
command again. For more information, see
“Checking the
If the mirror system does not respond to a command after
5 minutes (the timeout limit), the following error message
appears:
Links between Systems for Unidirectional Remote Copy”
(page 80)
.
target system <sys_name> could not be
contacted
Stopping and Starting Remote-Copy Groups
To stop a single remote-copy volume group, issue the following command:
# stoprcopygroup <groupname>
To start a single remote-copy group, issue the following command:
# startrcopygroup <groupname>
To stop all remote-copy volume groups, issue the following command:
# stoprcopy -stopgroups
To stop remote-copy volume groups that match a pattern, issue the following command:
# stoprcopygroup -pat <pattern>
where <pattern> represents the pattern of volume group names (for example, Group*)
To start all remote-copy volume groups, or to start remote-copy volume groups that match a pattern,
use the following command:
# startrcopygroup -pat <pattern>
where <pattern> represents the pattern of volume group names (for example, Group*)
Stopping and Starting Remote-Copy Groups 93