HP 3PAR Operating System Software User Manual
Page 50
where:
•
<target_name>
—Name of the target system (System1)
•
FC
—Defines link as an FC link
•
<node_WWN>
—WWN of the node on the target system
•
<N:S:P:WWN>
—FC adapter port on the primary system (System2), expressed as
node:slot:port, and the WWN of the peer port on the current system (System1)
Checking the Links between Systems for M-to-N Remote Copy
Follow these steps to check links between systems.
1.
To check the links between the primary and backup systems, issue the showrcopy command
on the backup system (System2):
# showrcopy
It might take several minutes for the links to come up between the two storage systems.
NOTE:
See the HP 3PAR Command Line Reference for complete details on the showrcopy
command, including valid synchronization, link, and group states.
To access this document, go to the HP 3PAR StoreServ Storage site and click the Support link
for your product:
2.
Verify the following:
•
The Status of the Target Information area is ready.
•
The Status of the Link Information area is Up for all the links.
The following example shows the showrcopy command output on the backup system
(System2):
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
System1 112 IP ready mirror_config
Link Information
Target Node Address Status Options
System1 0 10.100.24.108 Up
System1 1 10.101.24.108 Up
receive 0 10.100.24.108 Up
receive 1 10.101.24.108 Up
50
Setting Up M-to-N Remote Copy