HP 3PAR Operating System Software - Manual (Page 77)

Figure 29 Unidirectional Remote-Copy Configuration—Example
Example backup system Example primary system
System2 System1 System name
125 112 System ID
four (only two shown) eight (only two shown) Nodes
2 and 3 0 and 1 Nodes dedicated to remote copy
System1 System2 Target system
IP address XXX.XX.2.10 IP address XXX.XX.1.10 Links
IP address XXX.XX.2.10 IP address XXX.XX.1.11
One corresponding virtual volume
(vv1_remote) One virtual volume (vv1)
One primary volume group (Group1)
Virtual volumes and volume groups
One corresponding secondary volume
group (Group1.r112)
Verifying Connectivity between Remote-Copy Pairs for Unidirectional Setup
Issue the following command to verify connectivity for the remote-copy pair you are configuring.
•
For RCIP remote-copy pairs:
# controlport rcip ping <IP_address> <N:S:P>
Verifying Connectivity between Remote-Copy Pairs for Unidirectional Setup 77