HP PSC 2350 All-in-One Printer User Manual
Page 118
6
Press the
On
button to turn off the HP all-in-one.
7
Unplug the power cord, and then disconnect it from the HP all-in-one. Do not return the
power cord with the HP all-in-one.
Warning
The replacement HP all-in-one will not be shipped with a power cord.
Store the power cord in a safe place until the replacement HP all-in-one arrives.
8
Remove the control panel overlay as follows:
a
Make sure the color graphics display is lying flat against the HP all-in-one.
b
Raise the lid.
c
Place your thumb along the groove on the left side of the control panel overlay. Gently
remove the control panel overlay from the device as shown below.
9
Retain the control panel overlay. Do not return the control panel overlay with the HP all-in-
one.
Tip
See the Setup Guide that came with your HP all-in-one for instructions on how to attach
your control panel overlay.
Warning
The replacement HP all-in-one might not come with a control panel
overlay. Store your control panel overlay in a safe place, and when the replacement
HP all-in-one arrives, reattach your control panel overlay. You must attach your
control panel overlay to use the control panel functions on the replacement HP all-
in-one.
10
If available, pack the HP all-in-one for shipment by using the original packing materials or the
packaging materials that came with your exchange device.
User Guide
115
G
et HP
support