HP PSC 2350 All-in-One Printer - Manual (Page 93)

Note Do not remove both print cartridges at the same time. Remove and clean
each print cartridge one at a time. Do not leave a print cartridge outside the
HP all-in-one for more than 30 minutes.
4 Place the print cartridge on a piece of paper with the ink nozzles facing up.
5 Lightly moisten a clean foam rubber swab with distilled water.
6 Clean the face and edges around the ink nozzle area with the swab, as shown
below.
1 Nozzle plate (do not clean)
2 Face and edges around the ink nozzle area
Warning Do not clean the nozzle plate.
7 Slide the print cartridge back into the slot. Push the print cartridge forward until it
clicks into place.
8 Repeat if necessary for the other print cartridge.
9 Gently close the print-carriage access door and plug the power cord into the back
of the HP all-in-one.
Change the device settings
You can change the power save time and prompt delay time settings on your HP all-in-
one so that it behaves according to your preference. You can also restore the device
settings to what they were when you purchased your device. This will erase any new
defaults you have set.
Set the power save time
The light bulb in the scanner of your HP all-in-one remains on for a specified period so
that the HP all-in-one is immediately ready to respond to your request. When the
HP all-in-one has not been used within that specified period, it turns the light bulb off to
preserve power. You can exit this mode by pressing any button on the control panel.
Your HP all-in-one is automatically set to enter power save mode after 12 hours. Follow
these steps if you want the HP all-in-one to enter this mode earlier.
1
Press Setup .
2 Press 4 , then press 2 .
This displays the Preferences menu and then selects Set Power Save Mode
Time .
3 Press to select the appropriate time, then press OK .
Chapter 12
90 HP PSC 2350 series all-in-one
Maintain your
HP
all-in-one