HP PSC 2350 All-in-One Printer User Manual
Page 98
Solution
Make sure each of the power cords is firmly connected, and wait a few seconds for
the HP all-in-one to turn on. Also, if the HP all-in-one is plugged in to a power strip,
make sure the power strip is turned on.
My USB cable is not connected
Solution
You must first install the software that came with your HP all-in-one before
connecting the USB cable. During installation, do not plug in the USB cable until
prompted by the onscreen instructions. Connecting the USB cable before prompted
can cause errors.
Connecting your computer to your HP all-in-one with a USB cable is
straightforward. Simply plug one end of the USB cable into the back of your
computer and the other into the back of the HP all-in-one. You can connect to any
USB port on the back of your computer.
Note
AppleTalk is not supported.
User Guide
95
Troubleshooting
information