HP PSC 2350 All-in-One Printer - Manual (Page 92)

1 Copper-colored contacts
2 Ink nozzles (do not clean)
8 Slide the print cartridge back into the slot. Push the print cartridge forward until it
clicks into place.
9 Repeat if necessary for the other print cartridge.
10 Gently close the print-carriage access door and plug the power cord into the back
of the HP all-in-one.
Clean the area around the ink nozzles
If the HP all-in-one is used in a dusty environment, a small amount of debris might
accumulate inside the device. This debris can include dust, hair, carpet, or clothing
fibers. When debris gets on the print cartridges, it can cause ink streaks and smudges
on printed pages. Ink streaking can be corrected by cleaning around the ink nozzles as
described here.
Note Clean the area around the ink nozzles only if you continue to see streaks and
smudges on your printed pages after you have already cleaned the print
cartridges by using the control panel or the HP Image Zone. For more
information, see
Clean the print cartridges .
Make sure you have the following materials available:
●
Dry foam rubber swabs, lint-free cloth, or any soft material that will not come apart
or leave fibers.
● Distilled, filtered, or bottled water (tap water might contain contaminants that can
damage the print cartridges).
Warning Do not touch the copper-colored contacts or ink nozzles. Touching
these parts can result in clogs, ink failure, and bad electrical connections.
To clean the area around the ink nozzles
1 Turn on the HP all-in-one and open the print-carriage access door.
The print carriage moves to the far right side of the HP all-in-one.
2 Wait until the print carriage is idle and silent, and then unplug the power cord from
the back of the HP all-in-one.
3 Lightly press down on the print cartridge to release it, and then pull it toward you
out of the slot.
User Guide 89
Maintain
your
HP all-in-one