HP 3PAR Application Software Suite for Microsoft Exchange - Manual (Page 129)

C.19 Description of Events
3PAR Recovery Manager 4.1.0 For Microsoft Exchange 2010 User’s Guide
3220 RME3220: ERROR: The backup
you would like to restore is
not found. Please check your
parameters.
A restore for the specified
backup could not be
performed.
■ Check the syntax for the
RMExch backup command.
3501 RMCOMN3501: ERROR: The
volume is spread across
multiple InServs. This
configuration isn't supported.
The database or log target
volume cannot be spread
across multiple InServs as this
configuration is not
supported.
■ Refer to the preferred
configuration setup.
3801 3PARVSS3801: ERROR: Invalid
timeout value specified. The
valid range is <number 1> to
<number 2> seconds.
An invalid timeout value has
been specified.
■ Verify that specified timeout
value is within the supported
range of 3 minutes (180 sec)
to 10 minutes (600 sec).
3802 3PARVSS3802: ERROR: Invalid
retry value specified. The
valid range is <number 1> to
<number 2>.
An invalid retry value has
been specified.
■ Verify that specified retry
value is within the supported
range of 0 to 10.
3803 3PARVSS3803: ERROR: Unable
to access connection setup.
The connection setup could
not be accessed.
■ Verify that the 3PAR VSS
Provider Registry Key is still
valid on the system. If the
Registry Key cannot be
found, reinstallation is
required.
Table C-1. Recovery Manager for Microsoft Exchange Event Messages (continued)
Event ID Error Message Description/Action