HP LaserJet 4345 Multifunction Printer series - Manual (Page 222)

Control panel message Description Recommended action
58.XX ERROR To continue turn
off then on A temporary printing error has occurred. Turn the MFP off, and then turn the MFP
on.
If this message persists, contact an HP-
authorized service or support provider.
(See the HP support flyer, or go to
http://www.hp.com/support/lj4345mfp .)
59.XY ERROR To continue turn
off then on A temporary printing error has occurred. Turn the MFP off, and then turn the MFP
on.
If this message persists, contact an HP-
authorized service or support provider.
(See the HP support flyer, or go to
http://www.hp.com/support/lj4345mfp .)
60.X ERROR To continue turn off
then on The tray specified by X is not lifting
correctly. Follow the instructions in the onscreen
dialog box.
62 NO SYSTEM To continue turn
off then on A problem exists with the MFP firmware. Turn the MFP off, and then turn the MFP
on.
If this message persists, contact an HP-
authorized service or support provider.
(See the HP support flyer, or go to
http://www.hp.com/support/lj4345mfp .)
64 ERROR To continue turn off
then on A scan buffer error occurred. Turn the MFP off, and then turn the MFP
on.
If this message persists, contact an HP-
authorized service or support provider.
(See the HP support flyer, or go to
http://www.hp.com/support/lj4345mfp .)
66.XY.ZZ OUTPUT DEVICE
FAILURE An error occurred in an external paper-
handling accessory. 1. Turn the MFP power off.
2. Check that the accessory is properly
seated on and connected to the
MFP, without any gaps between the
MFP and the accessory. If the
accessory uses cables, disconnect
and reconnect them.
3. Turn the MFP power on.
4. If this message persists, contact an
HP-authorized service or support
provider. (See the HP support flyer,
or go to
http://www.hp.com/support/
lj4345mfp .)
68.X PERMANENT STORAGE
FULL To continue touch OK The MFP NVRAM is full. Some settings
saved in the NVRAM might have been
reset to the factory defaults. Printing can
continue, but some unexpected
functions might occur if an error
occurred in permanent storage. Touch OK to clear the message. If the
message is not cleared, turn the MFP
off, and then turn the MFP on.
If this message persists, contact an HP-
authorized service or support provider.
(See the HP support flyer, or go to
http://www.hp.com/support/lj4345mfp .)
Control-panel messages (continued)
208 Chapter 10 Solving problems ENWW