HP e-Commerce Server Accelerator sa7120 - Manual (Page 107)

C H A P T E R 6 Remote Telnet Sessions
97
Remote
Console,
Telnet With remote Telnet enabled on the SA7100/SA7120, use the
following procedure to access it’s CLI:
NOTE: If other remote
sessions are already
running and the new one
exceeds the number
allowed as configured
with the set
max_remote_sessions
command, the CLI
displays the message,
“Max Remote Session
Limit of (5) exceeded!”
Either close a session, or
increase the maximum
number allowed. Unix-prompt> telnet 10.1.1.1
Trying 10.1.1.1...
Connected to 10.1.1.1.
Escape character is ’^]’.
.
.
.
Serial 0:a0:a5:11:4:2e
password:<password>
After you enter your password, the Telnet session displays the
SA7100/SA7120’s CLI. From this point, you can manage the device
as you would from the local serial console, minus the few disallowed
commands listed in the “Limitations” section near the beginning of
this chapter.
Changing the
Telnet Port The Telnet port is set and displayed by using the CLI commands set
telnet_port <port > and show telnet_por t.
These commands are available only at the local serial console and
when the remote management is enabled. By default, the Telnet port
number is 23.
To set the Telnet port:
HP SA7120> set telnet_port 230
To display the Telnet port:
HP SA7120> show telnet_port
Telnet Port Number: 23 0