HP e-Commerce Server Accelerator sa7120 - Manual (Page 108)

C H A P T E R 6 HP e-Commerce Server Accelerator SA7100/SA7120 User Guide
98
Disabling
Telnet Telnet sessions are disabled at the SA7100/SA7120’s local serial
console. To disable, follow the steps below:
HP SA7120> set telnet disable
To verify Telnet disable:
HP SA7120> show telnet
Telnet: disable
To ensure that Telnet sessions remain disabled across a device
shutdown and startup, run the config save command.
Remote SSH Sessions
NOTE: The default user
name and password for
SSH sessions are admin. This section contains procedures for accessing the SA7100/SA7120’s
CLI via remote Secure Shell (SSH) session. The table below
illustrates ciphers supported by the domestically available SA7120
under SSH1 and SSH2. The export version of the product supports
only the SSH2 cipher DES.
Supported Ciphers
Local Serial
Console Assign an IP address to the SA7100/SA7120’s network interface
using the following procedure:
HP SA7120> set ip
Enter IP [10.1.2.56]: 10.1.1.1
Enter Netmask [255.255.255.0]:
Verify the IP and netmask (optional):
HP SA7120> show ip
System IP Address: 10.1.1.1
System Netmask: 255.255.255.0.
Enable remote SSH sessions:
HP SA7120> set ssh enable
SSH1 SSH2
Cipher 3DES, DES, Blowfish 3DES, Twofish, RC4,
“None”
MAC MD5, “None”