HP e-Commerce Server Accelerator sa7120 - Manual (Page 89)

C H A P T E R 5 Command Reference
79
Alarms and
Monitoring
Commands
Command Description
set alarms Enable all or a selection of the SA7120’s alarms.
Syntax:
HP SA7120> set alarms
<all none esc rsc utl ovl nls>
where
all enables all five of the SA7120’s alarms.
esc enables the Encryption Status Change Alarm.
rsc enables the Refused SSL Connection Alarm
utl enables the Utilization Threshold Alarm
ovl enables the Overload Alarm
nls enables the Network Link Status Alarm
To disable all alarms, use none:
Example:
HP SA7120> set alarms all
HP SA7120> show alarms
Alarms set: esc rsc utl ovl nls
show alarms Display the list of currently enabled alarms.
Example:
HP SA7120> set alarms none
HP SA7120> show alarms
Alarms set:
NOTE: When no alarms are set (i.e., when none is specified in set
alarms), the display shows an empty field.
set rsc_window Set interval (window) at which the device checks for refused SSL
connections and, if any are detected, issues an RSC Alarm.
(Range: 5-65000 seconds, default: 15)
Syntax:
HP SA7120> set rsc_window <sec>
where <sec> is the number of seconds of the desired interval.