Automapping, Automapping with multiple port combinations, Deleting automapping entries – HP e-Commerce Server Accelerator sa7120 User Manual
Page 40
C H A P T E R 3 HP e-Commerce Server Accelerator SA7100/SA7120 User Guide
30
Automapping
NOTE: Remember to
save the configuration
(with the config save
command) after making
mapping changes.
Automapped entries are identified by a server IP address of zero
(0.0.0.0). When a server IP address of zero is specified, the SA7100/
SA7120 intercepts packets to any server IP address with the matching
network ports. As with any mapping entry, the combination of server
IP address and network port must be unique.
The initial configuration for the SA7100/SA7120 provides an
automapping entry for network port 443 and server port 80. This is
associated with the internally generated default keypair and
certificate with the keyID of “default.” Under this initial
configuration, automapping occurs on any server with this network
port (443) when traffic is routed through the SA7100/SA7120.
Automapping with user-specified key and
certificate
When a user-specified key and certificate are to be automapped, the
user can replace the initial automapping entry with the create map
command. By specifying the same unique identifier (server IP of
0.0.0.0, and network port of 443) with a user-generated keyID, the
user can overwrite the initial automapping entry. (The key and
certificate may be obtained through any of the methods described
previously in this chapter.)
Automapping with multiple port combinations
The user can specify multiple automapping entries when the network
port is unique. For example, a user might specify, in addition to the
initial network (443) and server (80) port combination, a combination
of network (8010) and server (80) port.
Deleting automapping entries
Any automapping entry can be deleted, but if the initial automapping
is deleted and no other mapping entry is specified, the SA7100/
SA7120 automatically recreates the initial automapping entry. Either
replace the initial automapping entry or create another mapping/
automapping entry and then delete the initial automapping entry
using the delete map command.