HP 3PAR Operating System Software - Manual (Page 242)

RCIP Tab
The RCIP tab displays a summary of all Remote Copy over IP (RCIP) ports on a system.
The upper pane of the RCIP tab displays summary information about the system's RCIP ports. The
lower pane displays details about a selected RCIP port from the upper pane.
The following information is displayed in the upper pane:
Description Column
The location of the port in node:slot:port format. Position
The Media Access Control (MAC) address of the connected device. MAC
The state of the port. See “System and Component Status Icons” (page 41) . State
IP address of the RCIP port. IP Address
Netmask address for the RCIP interface. Subnet Mask
The address of a local IP router on the same network as the system, used to forward
traffic to destinations beyond the local network. Gateway
Maximum Transmission Unit. The greatest amount of data or "packet" size that can be
transferred in one physical frame on a network. MTU setting for the iSCSI port. The MTU
default setting is 1500. When supported by the network, an MTU value of 9000 should
be used.
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps). When
there is no specified value, no connection exists. Rate
The following information is displayed in the lower pane:
Description Field Group
Port location. Location General
Indicates whether the port is FC, iSCSI,
RCIP, or RCFC. Type
Rate that data can be transferred over the
port (1 Gbps, 2 Gbps or 4 Gbps). When Rate
there is no specified value, no connection
exists.
242 Viewing Remote Copy Information