HP 3PAR Operating System Software - Manual (Page 243)

Description Field Group
Type of device that the port is connected
to. Free, Disk, Host, Peer, or InServ. Connected Device Type
Name of device that the port is connected
to, e.g. host1, cage0. Connected Device
Port firmware mode setting. Ports in Initiator
mode are connected to drive cages and Mode
ports in Target mode export to hosts.
Suspended mode is for target ports that
have not yet been initialized by the system
(rare). Peer mode is for Ethernet ports.
Current state of the port. State
The Media Access Control address for the
Ethernet interface. MAC IP Settings
IP address of the RCIP port. IP Address
The address of a local IP router on the same
network as the InServ, used to forward Gateway
traffic to destinations beyond the local
network.
Netmask address for the RCIP interface. Subnet Mask
Maximum Transmission Unit. The greatest
amount of data or "packet" size that can MTU
be transferred in one physical frame on a
network. MTU setting for the iSCSI port.
The default setting is 1500. When
supported by the network, an MTU value
of 9000 should be used.
The duplex speed, Half or Full. Configured Rate
Model of the adapter that contains the port
(for example, Intel PRO/1000MT). Duplex
The TCP port number used by the iSCSI or
RCIP card. Adapter Type
The throughput in KB/sec. Total Data Throughput Resources
RCFC Tab
The RCFC tab displays a summary of all Remote Copy over Fibre Channel (RCFC) ports on a system.
Viewing Remote Copy System Ports 243