Ag Leader GeoSteer Operation Manual - Manual (Page 116)

RTK
102 GeoSteer System
Using the Update Saved Location Procedure
1. Power on the Base Station at the job location. Allow the Base Station to run and surveyed in (this can take 24 hours or
longer to complete).
2. Power on the Rover. An Initial (and inaccurate) position is displayed in the Saved Location field.
3. Begin work on the part of your job that does not require accurate latitude/longitude or repeatability.
4. After the Base Station has completed a 24 hour survey, navigate from the GPS tab. Press the RTK button and then
highlight Base Station Location from the list on the left.
5. If the Base Completed 24hr Survey shows Yes, press the Update button shown in Figure 4-13
6. A confirmation prompt appears. Press the Green Check button if you agree with the confirmation prompt or press the
Red X button to cancel.
Figure 4-14 Confirmation Screen
7. The Saved Location is now updated and the Base Station Location screen reappears.
Figure 4-15 Base Station Location
8. Begin your next work session. All subsequent work will be repeatable and have accurate latitude and longitude. You will
not need to use the Update function again for this Base Station.