Ag Leader GeoSteer Operation Manual - Manual (Page 31)

Changing SIM Card in GeoSteer
Operator’s Manual 17
2. Loosen the two screws holding the SIM Card slot cover on with a 2mm Allan wrench supplied with the GeoSteer System
and remove the cover. The screws stay attached to the cover.
Figure 1-20 Remove Cover by Loosening Screws
3. The edge of the SIM Card will be visible. Gently push the SIM card into the slot and then release. The SIM Card should
pop out of the slot.
Note: The SIM Card cover has a flat blade that can be used to assist in pressing the SIM Card in so it will release.
Figure 1-21 Remove SIM Card
4. Verify that the area around the SIM Card slot and the SIM Card cover are clean. If necessary clean with a damp cloth and
allow it to dry before reassembling.
5. Insert the new SIM Card into the slot.
Note: The SIM Card cover shows how the notch on the SIM card needs to be orientated when inserting into the slot.
Verify the SIM card is orientated properly before inserting.
Remove Screws
Press SIM Card in