Ag Leader GeoSteer Operation Manual - Manual (Page 141)

NMEA Out
Operator’s Manual 127
Port Configuration
Note: Changing the Baud Rate for Port A on the NMEA Out screen also changes the Baud Rate for the External Radio input.
Port A can be used simultaneously for the External Radio In and NMEA Out, however both functions must use the same Baud
Rate.
To change the Port Configuration, follow the procedure below:
1. Press the Change Baud Rate button.
2. If adjusting Port A, a Warning message will appear. Press the Green Check button to accept it or the Red X button to
cancel.
Figure 4-53 Port A Warning Message
3. Use the Gray Up/Down Arrow buttons or directly select the desired baud rate. Press the Green Check button to accept
changes or the press the Red X button to cancel.
Figure 4-54 Port Available Baud Rates
Port B Message
The procedures to enable and edit Port B are identical as steps described for Port A.
Port B Configuration
The procedures to set the baud rate for Port B are identical as the steps described for Port A except where noted.