Ag Leader ParaDyme Radio Option Kits Hardware Installation Guide - Manual (Page 15)

Hardware Installation Guide 9
3
Radio Modem Kits Installation Overview
This chapter contains information in the following sections:
•
Pre-Installation Verification
•
Kit Overviews
•
OmniSTAR Receiver Kit
•
900 MHz Radio Modem Kit
•
UHF Radio Modem Kits
•
VHF Radio Modem Kits
Pre-Installation Verification
Note: ParaDyme cell modems are factory configured for specific countries. Contact your dealer for further cell modem
information.
1. Ensure your work area is clean and safe before you start any installation procedure.
2. If possible use the foam packing material used to ship the ParaDyme system to protect it from damage while it is placed on
the desk. Alternatively, two 4x4 (10cm x 10cm) blocks of wood can be used as spacers to keep the Roof Module secure on
the work space.
3. Check the general working condition of the Roof Module. It should be fully functional.
4. Verify that you have received all the parts with your kit before starting the installation. See Kit Overviews on page 10.
5. Ensure you have all the necessary tools to complete the installation. See the Special Requirements on page iii.