Ag Leader ParaDyme Radio Option Kits Hardware Installation Guide - Manual (Page 28)

22 Radio Option Kits
OmniSTAR Receiver Kit Installation Procedure (200-0504-02 Kit)
3. Mount the OmniSTAR printed circuit board taking care to verify that all the pins line up.
Note: Failure to line up the pins could cause damage to the circuit board and invalidate the warranty.
Figure 4-12 Verify Pins Line up when Attaching OmniSTAR Circuit Board
4. Attach the OmniSTAR circuit board with three M2 x 14mm screws provided. Torque the three screws to 2 in-lb (0.2
Newton meters) with a #0 Phillips driver.
Figure 4-13 OmniSTAR Circuit Board Installed
OmniSTAR Circuit Board
Screws